Hello Guest it is March 30, 2020, 09:30:55 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - jso9766

Pages: 1
General Mach Discussion / input not working????
« on: January 31, 2008, 11:13:10 PM »
ok, so i am just now getting my system up and running and can not get the inputs to work.

I have the parallel port set to ECP(have tried bi-directional)

I am running the cnc4pc breakout board for gecko's with g320's

I have motion and all my outputs work, however the inputs, thought the led's on the BOB work correctly are not recognized by my computer. 

I am running winxp.  Any thoughts?  Would the windows firewall be a culprit? 


Pages: 1