Hello Guest it is September 16, 2019, 07:05:20 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Trell

Pages: 1
1
General Mach Discussion / WTF old copy of Mach3
« on: October 18, 2011, 08:26:41 PM »
I had an old copy of mach3 hooked up to the CNC and it was working fine on jog. But it would only run about 20k lines of code.
I tried to update Mach3 but it did the same thing. Next I uninstalled Mach3 and reinstalled the software, installed the license for mach3, Set all the pins for the motors
now it want even Jog Mach3 software on the screen says that the unit is moving but the CNC does not move ????..........but now Mach3 sees all the G Code
Has anyone got any ideas
Trell

Pages: 1