Topics

1

General Mach Discussion / screw mapping backwards?

« on: May 20, 2009, 08:08:00 AM »

hello everyone,

i've started to map my screws, taking data every 2 inches.

i would move to my target, input the actual position and add the point.

When i turn on screw correction, it actually doubled the error at each point.. for example.

i move to 12" on x.  True position is 12.008.  With screw mapping turned on, i get 12.016 as position when i remap the screw.

anything i did wrong?

2

VB and the development of wizards / reading mouse movement?

« on: January 19, 2008, 11:03:18 PM »

Hello,

I have a project where i would like to monitor and analyze mouse movement from within Mach.

Is this something i can do within the scripting language? Or will i need something to pass the data into mach

Thanks for your help!  just need some direction