Hello Guest it is March 28, 2024, 04:35:13 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Vicky

Pages: 1
1
General Mach Discussion / losing steps when i use the stop button
« on: August 22, 2008, 10:23:53 AM »
Hi everyone,

I'm having a problem when a use the stop button on my screen. This is because when the program is running and i active it, the X axis lose steps and the led of my X motor driver turns on. I'm using servo motors in each axis with the G340 Geckodrive driver.

The velocity of my X servo motor is 315 inch per minute, so i suppose that  the problem is about a desacceleration when it stops the program. Because i've tried to stop the running program using the following steps: First I press the pause button and then i press the stop button to turn off the spindle and rise the z axis.

Is there a way to configure a desacceleration of this function, like the motors config?  ???

Vicky

Pages: 1