Hello Guest it is November 27, 2022, 06:08:02 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - puckee

Pages: 1
1
General Mach Discussion / gcodes
« on: January 02, 2008, 12:07:58 AM »
hello and happy new year i am new to the post and hope someone can help I am interested in ramping the feed rate over a distsance  rather than stair stepping the changes
I would like it to be smooth any ideas are appreciated  PS this is for a lathe profiling bats

Pages: 1