1
General Mach Discussion / Mach 3 controller not responding after?
« on: January 01, 2008, 10:07:16 PM »
Hello and let me say it's nice to see so many thinkers out there. I have been running Mach 3 first version and updated to the lastest and noticed that after a rebot the following morning it would not respond / the table would not move. So I have a spare backup computer and I switch over to check with the older version and it worked perfectly. So I checked the config and everything matched up, so I had to completely remove the install and reinstall the older version. Running Windows XP with 3ghz processor. Any thoughts??