1
FAQs / Intermittent error with Mach3
« on: December 24, 2009, 02:07:37 AM »
Hi, I have been having intermittent errors when I run GCode files. Right at the start where Mach is given an M3 command, I sometimes get a popup that says Error in Line (Line number) - Unspecified Failure and the program stops. If I then hit cycle start again the program continues, but does not start the spindle. It doesn't do it all the time, but when it does it I have to restart Mach3, then the problem usually goes away. Has anyone else had this problem?
I am using version R2.61 of Mach3.
Thanks,
John
I am using version R2.61 of Mach3.
Thanks,
John