1
General Mach Discussion / Encoder suggestions
« on: December 24, 2007, 12:34:47 PM »
I am beginning to convert my mini-mill to a CNC; this is my first conversion. I currently have the Xylotex board and stepper motors. Does anyone have any suggestions when it comes to encoders? Which encoders would you recommend?
Right now I am planning on using Mach 3. Will Mach 3 get the table position from the encoders and not just the counts on the stepper motors?
Thank you,
Ma*********
Right now I am planning on using Mach 3. Will Mach 3 get the table position from the encoders and not just the counts on the stepper motors?
Thank you,
Ma*********