Hello Guest it is December 06, 2023, 12:15:21 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - golddust mfg

Pages: 1
General Mach Discussion / homing swithes
« on: July 07, 2008, 04:56:53 AM »
I am hoping that someone could help me ,when i turn on my mach do the X home bar light and the Y home light suppose to be on? mine are and i can not use the switches X and Y
Z axis works and the probe works also ,i did unplug the controller and they are still lit up


General Mach Discussion / home swithes problem
« on: June 04, 2008, 01:03:28 AM »
Hello My name is johan and i have been at artcam for awhile ,i have a minitech milling mach ,my 3th machine keep upgrading ,well on this new mill i have home switches ,very cool but i have a small problem the led green light bars on axis x and y stay on ,but the light on the switches by them self will come on when i put a piece of metal in front of them ,but they still don't stop the axis , what am i doing wrong?
the probe light comes on when activated and also the z axis switch could any body give me some info? i read the manual ,but no luck
thank you ,Johan i live in canada ,Alberta ,medicine hat

General Mach Discussion / milling problems
« on: January 19, 2008, 10:52:48 AM »
Would there any one out there ,that could tell me if there any setting beside motor tuning ,that could make a distortion in my milling ,i mill wax ,round become oval and square become rectangle,
On a flat or rotary it is the same ,motor tuning is fine i made a block 10mm and that came out fine ,but as soon as i load a toolpath in it goes wacky.HELP

General Mach Discussion / problems with cnc cutting oval
« on: December 19, 2007, 09:19:17 PM »
Hi Every one ,sorry i am very new here on this forum ,i have a problem with my  cnc minitech milling machine cutting oval instead of round,can anyone help me with this?
thank you

Pages: 1