Hello Guest it is February 18, 2020, 06:10:32 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - JOE65

Pages: 1
1
General Mach Discussion / SURFACE WIZARD
« on: June 03, 2006, 01:35:42 PM »
I'm trying to use the Surface with tool down in x Wizard and not having much luck.

I'd like to rough cut to a certain z height and then slow feed rate down for finish cut last .002.

Is there info somewere on this wizard?



Pages: 1