Hello Guest it is March 29, 2024, 12:50:07 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Garyh

Pages: 1
1
General Mach Discussion / Z stepper jerky
« on: June 23, 2008, 07:46:26 AM »
Hi all, just built a new router with stepper system and Z axis seems to pulsate when running a 3d file. I have tryed all types of motor tuning with
the same result every time? The Z is 1:1 with ball skrew 5mm x1 rev. lift,X-Y have 34 to 72 belt drive and 26t pinion drives,all drives jog around
the table fine. Cuts 2 1/2 fine but when i try 3d files Z seems to run rough. Any help would be great.cheers.

2
G-Code, CAD, and CAM discussions / Powermill to Mach3 post
« on: April 22, 2007, 08:13:36 AM »
Can any one help ?

Pages: 1