1
General Mach Discussion / Output signal
« on: August 12, 2014, 11:27:45 PM »
Hello to All
Well I have a problem with my Output signal from output 6 is active but as far as i know nothing is mapped to it,try to restart the computer,also the program,but nothing worked.After that check all my connections to the different switches but all of them look good.
Any ideas?
Thanks
Marco.
Well I have a problem with my Output signal from output 6 is active but as far as i know nothing is mapped to it,try to restart the computer,also the program,but nothing worked.After that check all my connections to the different switches but all of them look good.
Any ideas?
Thanks
Marco.