Hello Guest it is March 29, 2024, 11:56:19 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - George V

Pages: 1
1
Ok, so I’m running Mach 3 with a MicroMill 2000. When I use the Multi Pass wizard I get a random loss of position. ( .180 inches out in the  X)  I have gone thru the optimization and have done everything there. I ran fine for two hours and then BOOM. It pauses for a second and when it starts back up I’m out of position.  Any suggestions????

Pages: 1