1
General Mach Discussion / Mach 3 shifts the toolpath to the left after 3minutes of cutting? Parts overlap!
« on: November 07, 2009, 05:18:17 PM »
Hi,
this is my problem:
I make a G code with lazycam (tried both new and older version, does not solve the problem).
Import it into mach3.
It runs fine for 2-3 minutes.
After this, always at the same part, mach 3 shifts all of the parts to the left (see image).
this:
becomes this:
I have no idea why.
When I import the G code in mach is looks allright on the toolpath viewer, but when it runs it, it goes wrong.
Anyone can help me please?
Thank you
this is my problem:
I make a G code with lazycam (tried both new and older version, does not solve the problem).
Import it into mach3.
It runs fine for 2-3 minutes.
After this, always at the same part, mach 3 shifts all of the parts to the left (see image).
this:
becomes this:
I have no idea why.
When I import the G code in mach is looks allright on the toolpath viewer, but when it runs it, it goes wrong.
Anyone can help me please?
Thank you