Hello Guest it is April 14, 2021, 12:17:17 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - davestea

Pages: 1
1
General Mach Discussion / trouble with wizards -
« on: June 04, 2006, 11:55:20 AM »

the following are some of my observations and troubles with a couple of the wizards -
 
the OD groove wizard crashed M3 on two systems -
one has v84.000 and the other 001
 
one time it crashed so badly on the brand new system that I got with my Sherline lathe, that I couldn't even reboot.  It left a process running that I could not quit from the task manager.  Tried to reboot - but then it would not close down I guess because of the M3 process that would not unload.  Had to reset the system.  Hate to do that to Windows.
 
The id arc seems to want to cut into -X by .1" -- I went over that one a dozen times trying to figure out why it wouldn't work like I thought it should.  Reset home and x/z 0 several times - still goes negative -- even the code says -X.1??"

any help out there?  Suggestions?  Work Around?

thanks -

ds\


2
General Mach Discussion / profiles quest
« on: May 24, 2006, 10:26:27 PM »

can someone tell me where I can find different brand mill profiles?

I'm specifically looking for the Taig mill -

thanks -

3
General Mach Discussion / newbee needs a little help
« on: May 22, 2006, 10:20:37 PM »
using M3 lathe Sherline R1.84

loaded by dealer on supplied system from TableTop.

acts the same as my demo copy -

clicking on file - import dxf does nothing at all -

what am I doing wrong?  tried all 3 main screens

ds


Pages: 1