Hello Guest it is March 04, 2021, 09:08:06 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - topmack

Pages: 1
1
General Mach Discussion / Setting up Mach3 to drive Stepmaster controller
« on: September 11, 2008, 10:19:04 PM »
Need help with setting up Mach3 to drive Stepmaster controller. It worked correctly at one time, however I can't seem to find the right 'switch' to cause the controller to move the motors. I have read the documentation and watched the videos ( many times!). I believe I am missing something very elementary. Please help.

Pages: 1