Topics

1

General Mach Discussion / need help with mach lathe

« on: December 12, 2008, 04:32:23 AM »

will mach 3 take a roughing canned cycle g71-g72- and a finish canned cycle g70 to make a radius then turned back at an angle, also will it accept g02 and go3 in the same canned cycle

hope you understand what im trying to say. need to do multiple rad. and ang. in same canned cycle..

if so could you give an example

thanks

2

General Mach Discussion / Run From Here not working

« on: November 17, 2007, 01:52:42 AM »

I updated my Mach 3 from Version 1.9 to 2.6 and now I can't get my run from here function to work......is there a place that it might be turned off....?