1
General Mach Discussion / Problem
« on: October 24, 2006, 04:26:58 PM »
Upgraded the "computer" to a biostar motherboard and AMD 64 about 2.4g.
G0 moves the axis, G1 won't move at all....no errors (I'm not using feedback of any kind, 1 axis driller). Readout moves, axis won't.
I put it on another computer and it works fine. I'm sure the configs are identical. Has anyone had problems with certain hardware acting goofy?
G0 moves the axis, G1 won't move at all....no errors (I'm not using feedback of any kind, 1 axis driller). Readout moves, axis won't.
I put it on another computer and it works fine. I'm sure the configs are identical. Has anyone had problems with certain hardware acting goofy?