1
General Mach Discussion / Tool change location button
« on: September 01, 2006, 01:41:00 PM »
Hi,
This is probably very simple but I seem to be overlooking the answer. How do I change the coordinates (X,Y,Z) for the "Tool Change Location".
Is this changed within Mach 3 as a setting or are these coordinates set when I load my G-code from my pp.
Thanks in advance for everyones help.
Chris
This is probably very simple but I seem to be overlooking the answer. How do I change the coordinates (X,Y,Z) for the "Tool Change Location".
Is this changed within Mach 3 as a setting or are these coordinates set when I load my G-code from my pp.
Thanks in advance for everyones help.
Chris