Hello Guest it is March 29, 2024, 06:31:38 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - brianhuppi

Pages: 1
1
Recently I upgraded my Camtronics CNC drive from stepper to servo drive.  I now notice that when compensating for backlash it takes much longer than it did with the stepper system.  Has anyone seen this?  Can it be corrected or is it something that has to be lived with?

I would appreciate if anyone could shed some light on this.

THanks!

2
General Mach Discussion / MPG mode - how to set???
« on: May 19, 2006, 12:04:26 AM »
OK I need help.  I just added a second parallel port so I could add my MPG and get better performance than with keygrabber.  I think I have it all connected correctly but cannot figure out for the life of me how to get Mach2/3 into MPG mode.  When I toggle the jog modes I can only get incr and continous.  Can someone explain to me what bone-head mistake I'm making here?

Thanks!

+brian

Pages: 1