Hello Guest it is April 14, 2021, 05:14:14 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - jaru-eri

Pages: 1 2 »
General Mach Discussion / Problem with generated rotary job toolpath.
« on: March 04, 2019, 11:07:42 PM »
I refer to my topic in Vectric forum and need help in order to find out why my generated g-codes gives a different machining toolpath than it was shown in the v-carve softvare.

Are there anybody here who can help me with this issue?

General Mach Discussion / How do I configure the A-axis settings?
« on: February 22, 2019, 10:56:19 PM »
What do I need to do in order to configure Mach3 to know when the rotary axis has done a full 360 degr. rotation?

In the middle of a job, the z-axis lost some steps and continued engraving 0.5mm deeper. Which kind of settings do I need to adjust in order to avoid that. Will it be best to reduce the speed or the acceleration of the stepper motor?

General Mach Discussion / Best Screenset for Mach3?
« on: August 07, 2018, 05:38:25 PM »
What will be the best screenset for Mach3 to buy today?

General Mach Discussion / Problems with ver. ...062 on WinXP
« on: August 06, 2018, 09:34:01 PM »
When i try to load a g-code with a half-sphere on winXP machines, the image comes out like this and the machining toolpath acts in the same way. It goes longer in -x direction than in the other directions. What may be wrong?

I have reinstalled  after a disc crash to a newer version of Mach3 and need to transport the files of config. settings from another Mach3 program which I have on another PC. So I need to know which of the files in the Mach library that contain these settings and registration code.

Can anybody here help me whit this issue?

General Mach Discussion / Logitech g13 as pendant?
« on: March 09, 2012, 08:04:03 AM »
Any experiences regarding this gameboard as Mach3 pendant? Can the Lcd sreen be used as readout for the x, y z positions?

G-Code, CAD, and CAM discussions / Any cheap alternatives to Vectric?
« on: April 24, 2009, 02:19:42 AM »
Are there any free or cheap alternatives to Vectric PhotoVcarve and 2D/3D Carve on the web at this time?

General Mach Discussion / Ubuntu and CNC programs.
« on: January 26, 2009, 03:50:35 PM »
Is Ubuntu a good enough alternative to Win XP in order to run Cad/Cam programs like Mach3 etc. for cnc machining?

General Mach Discussion / Point cloud to G-code. What do I need?
« on: January 15, 2009, 07:12:55 PM »
Which inexpensive software do I need for converting point cloud to g-code?

Pages: 1 2 »