Guest
Show Posts
1
General Mach Discussion / M6 Toolchange not work with lathe
« on: November 02, 2007, 10:31:38 AM »
hello,
i can writhe on MDI or in the DIN code "M6 T3"
lathe ignorid this command,
i set Tool manualy too Tool 5
the screen show me Tool 5
i write "M6 T7"
the screen show me Tool 0, not 7
with the mill have i this Problem not, only with lathe
cu Peter
i can writhe on MDI or in the DIN code "M6 T3"
lathe ignorid this command,
i set Tool manualy too Tool 5
the screen show me Tool 5
i write "M6 T7"
the screen show me Tool 0, not 7
with the mill have i this Problem not, only with lathe
cu Peter