Topics

1

General Mach Discussion / Crazy zero

« on: July 06, 2019, 12:10:03 AM »

I have been trying for some time to get my Grizzly G0 704 mill to work correctly. Here is what happens. I did a design in Fusion 360 and did the code. When i try to start the program the tool is set to zero on the surface of the stock. When I press start the Z axis goes up usually till it hits the end of travel and keeps going loosing its place. is it with my code or is it my machine setup? I have a router that works great and this has me stumped. 

 Bruce

2

General Mach Discussion / backing off home switch

« on: April 26, 2016, 01:48:49 PM »

 Hello when my machine is set to ref all home the z-axis goes to trip the switch but it will not back off. The reset button lights and I have to turn the power off move it off the switch by hand then power it back up and hit the reset button. Then the machine will move again



    Thanks Bruce

3

General Mach Discussion / problems with ports

« on: April 26, 2009, 11:08:19 PM »

  Hello I am trying to set up a router table. I am having trouble getting the motors to turn. They just bump 1 time when i try to jog them. when i use other software they work ok. When I open the diagnostics page in Mach there is no indication of a signal on the parallel port pins at all. I used the same settings that worked on my other software. 

   please help