Hello Guest it is March 29, 2024, 04:11:50 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - dart70ca

Pages: 1
1
General Mach Discussion / Coordinate system rotation
« on: January 24, 2010, 01:31:07 PM »
    Does Mach3 support coordinate system rotation? The table on my MDF machine has some tilt to it that I can't remove right now and I would like to run a macro that will tilt the YZ and XZ axes to compensate for the worst of it.

                                                                                                                                                                       Thanks,
                                                                                                                                                                               Keith

Pages: 1