Hello Guest it is March 29, 2024, 03:00:37 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - bm1400

Pages: 1
1
Sieg Machines / sx3 spindle sensor
« on: January 30, 2011, 01:16:55 PM »
i have a sx3 running mach3 i was wondering is there any way to use the speed sensor to feed mach3 the speed info through a g540? . i have recently used it as a lathe but would like to rig up the spindle feedback for screw cutting

regards mick

2
General Mach Discussion / using x3 mill as a lathe
« on: January 25, 2011, 03:29:39 AM »
i am able to run my mill under the control of mach lathe but i dont understand how i can move they y axis. if i had 3 seperate tools clamped on the table how would i zerz each of these. any help would be great
regards mick

3
Mach Screens / using my mill as a lathe
« on: January 25, 2011, 03:27:54 AM »
i am able to run my mill under the control of mach lathe but i dont understand how i can move they y axis. if i had 3 seperate tools clamped on the table how would i zerz each of these. any help would be great
regards mick

4
Newfangled Solutions Mach3 Wizards / thread milling
« on: October 05, 2010, 04:21:34 AM »
when using the thread milling wizard.it only produces half the code could you please help

5
Forum suggestions and report forum problems. / MDI
« on: May 02, 2008, 08:00:15 AM »
hi i am using the latest download on my taig mill i have been cutting some very nice crossed helical gears but once the program has finnished i close the g code but cant get any responce from the MDI input can anyone help

6
G-Code, CAD, and CAM discussions / crank shaft
« on: December 29, 2007, 05:08:34 AM »
i am trying to make a crank for a small 4 stroke engine i have drawn up the crank with rino and when i try to generate the g code in rhinocam it is cutting the crank part off & leaving a spindle in the centre can anyone help

7
Forum suggestions and report forum problems. / metric or imperial
« on: December 02, 2007, 09:56:06 AM »
hi i have been having some great fun with my taig im running mach3, i like to work in mm but mach3 keeps jumping to inches & continuously flashes on the abnormal condition button i set it up originaly in mm but i cant understand this can anyone help

Pages: 1