Topics

1

General Mach Discussion / Dwell question

« on: July 17, 2006, 12:30:15 PM »

Hello, how can i trigger an output when the dwell command is active ? Thanks

2

LazyCam (Beta) / Help with LazyCam

« on: May 03, 2006, 12:56:56 PM »

I have this part with 2 layers, the 1 layer the outside of the piece the 2nd layer the circle in the middle of the piece.

I have tried everyway I can to get LazyCam to cut the circle on the inside instead of the outside. But it continues to cut outside . If I enable a straight lead-in of 3mm the leadin extends beyond the edge of the circle
Cosmy