1
Mach4 General Discussion / Mach4 Build 5036 - where did the Probe Calibration Tab go & MACH4 crashes
« on: April 01, 2023, 05:46:52 PM »
Hello community,
I had to reinstall MACH4 due to a system crash. I didn't have a backup (shame on me), but I did take screenshots of all configurations. So my new version of Mach4 was up and running within an hour. Now I have a backup :-)
Only: in the current version of Mach4, the Probe tab is missing in wx4.set and thus also the Calibration tab. There is now a separate screen for probing, but I couldn't find the option to calibrate my probe anywhere. How do I do that?
In my helplessness I installed an old version of Mach4 and exported the Probing Tab via the Screen Editor. When trying to import the export in the latest version of Mach4, Mach4 crashes.
So the question remains: how do I calibrate both my probe (3D touch probe) and my tool length sensor?
Maybe you have a hint for me.
Best regards
I had to reinstall MACH4 due to a system crash. I didn't have a backup (shame on me), but I did take screenshots of all configurations. So my new version of Mach4 was up and running within an hour. Now I have a backup :-)
Only: in the current version of Mach4, the Probe tab is missing in wx4.set and thus also the Calibration tab. There is now a separate screen for probing, but I couldn't find the option to calibrate my probe anywhere. How do I do that?
In my helplessness I installed an old version of Mach4 and exported the Probing Tab via the Screen Editor. When trying to import the export in the latest version of Mach4, Mach4 crashes.
So the question remains: how do I calibrate both my probe (3D touch probe) and my tool length sensor?
Maybe you have a hint for me.
Best regards