1
Mach4 General Discussion / No signal to laser pwm port
« on: March 27, 2024, 10:40:44 PM »
I'm sure this will be a easy fix and I am over seeing the issue.
My setup coinsist of Win 11, Mach4 4809 build, ESS 285 with laser screen installed I'm Using a MB3 BOB.
All other profiles work fine but I have been unable to get laser profile to test fire laser.
The ESS pin config. I have port3 pin 14 named as laser PWM, Port3 pin 16 named as Laser Gate,
In Outputs I have Laser PWM mapped to P3-14, and output#16 mapped P3-16.
Laser tab the laser gate assigned to #16. Allow test fire is checked.
My first thought was a bad 24v ( LT-80W-AA-Pro ) Laser but after connecting the PWM to a 5v source on the MB3 the laser did come on.
Tested P3-14 with ohm meter and no volts while test firing in mach4. I tried changing the power in ESS laser tab from 15.1 to 75 % and still no voltage.
If anyone could offer suggestions it would be greatly appreciated.
My setup coinsist of Win 11, Mach4 4809 build, ESS 285 with laser screen installed I'm Using a MB3 BOB.
All other profiles work fine but I have been unable to get laser profile to test fire laser.
The ESS pin config. I have port3 pin 14 named as laser PWM, Port3 pin 16 named as Laser Gate,
In Outputs I have Laser PWM mapped to P3-14, and output#16 mapped P3-16.
Laser tab the laser gate assigned to #16. Allow test fire is checked.
My first thought was a bad 24v ( LT-80W-AA-Pro ) Laser but after connecting the PWM to a 5v source on the MB3 the laser did come on.
Tested P3-14 with ohm meter and no volts while test firing in mach4. I tried changing the power in ESS laser tab from 15.1 to 75 % and still no voltage.
If anyone could offer suggestions it would be greatly appreciated.