Topics

1

General Mach Discussion / mach3 and hobbycnc board

« on: April 20, 2009, 08:39:44 PM »

 hello all, i need help setting up mach3 and hobbycnc board. i can not get the motors to move.  the motors lockdown when i turn on the box. is it mach3 are is hobbycnc?

2

General Mach Discussion / servo motors

« on: November 20, 2007, 09:16:29 PM »

if the servo motor stop because of over torque the the program stop to?

3

General Mach Discussion / closed loop

« on: November 04, 2007, 11:40:51 AM »

how do i set up a closed loop system in mach3 ?i went to used encoders with my steeper to make sure that i do not loose steps.

4

General Mach Discussion / brains

« on: November 04, 2007, 11:26:20 AM »

how do i get brains to come up on my screen

5

G-Code, CAD, and CAM discussions / loop question with mach3

« on: October 07, 2007, 05:29:05 PM »

how do i get the "z" axis to drop .062" with each pass?  i can get the program to repeat as may times that i want to.  but i can not get the "z" to drop with each pass. please help.