Hello Guest it is September 22, 2023, 01:48:05 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - Senzorbyh

Pages: 1
Mach3 and G-Rex / Why is the Auto Tool Zero button not working?
« on: February 27, 2023, 09:25:27 AM »
Hello, I have a 6040Z cutter. Do you know why the Auto Tool Zero button doesn't work for me?
When I open the script for the M930.m1s tool and load it, testing it with the Run Script button it works. The tool goes down to the probe, touches it and moves back a bit.
When I memorize the script and then press the Auto Tool Zero button, a “Not Yet Implemented” message appears.

This is the script:
'chengdu xhc tec. probe z surface macro
FeedCurrent = GetOemDRO(818)    'Get the current settings, OEM DROs (818)=Feedrate DRO
ZCurrent = GetOemDro(802)   'OEM DROs (802)=Z DRO
GageH = GetOEMDRO(1001)   'OEMDRO(1001)=Gage Block Height
ZNew = ZCurrent - 300      'probe down 20 mm

Code "G90F200"         'slow feed rate to 100 MM/MIN
Rem Code "G4 P1"         'Pause 1 second to give time to position probe plate
Code "G31 Z" &ZNew
While IsMoving()
Call SetDro (2,GageH)      'DRO(2)=Z DRO

FinalMove = GageH + 10
Code  "G0 Z" &FinalMove
Code "F" &FeedCurrent        'restore starting feed rate   

Pages: 1