1
General Mach Discussion / Update 3.041 to 3.043, axes not working.
« on: February 17, 2023, 12:52:56 PM »
Hello Everyone.
I am a newbie and I wanted to update mach3 installation to the newest version. To do so I renamed mach3 folder to mach3_old and installed new version under mach3 folder. I copied my license file, xml profile and bimaps folder.
Each time running the newest version from mach3 folder loading the copied xml profile I get always ReConfiguration eStop. I press reset and then using numpad arrows doesn't move my mill but the position values change on screen.
If I start mach3 from mach3_old folder, everything works ok.
Did I miss some another step to configure it all properly? What should I do to get it working with newest mach3 version?
Regards
Thwei
I am a newbie and I wanted to update mach3 installation to the newest version. To do so I renamed mach3 folder to mach3_old and installed new version under mach3 folder. I copied my license file, xml profile and bimaps folder.
Each time running the newest version from mach3 folder loading the copied xml profile I get always ReConfiguration eStop. I press reset and then using numpad arrows doesn't move my mill but the position values change on screen.
If I start mach3 from mach3_old folder, everything works ok.
Did I miss some another step to configure it all properly? What should I do to get it working with newest mach3 version?
Regards
Thwei