Hello Guest it is April 25, 2024, 05:11:43 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - les

Pages: 1
1
General Mach Discussion / DC Servo run away
« on: April 29, 2006, 05:10:24 PM »
While routing on wood ,every now and then the x or y axis runs away over the router table. I have Win XP & Mach2 installed on a 1.3ghz Athlone,I did setup XP according to XP optimization txt file. I have tried with another PC 3Ghz and 500MHz Intel and I have the same problem. I have taken a storage scope to monitor the step pulse and found that there is a inrush of pulses during the moment the x or y axis runs away.These pulses have about 3x the frequency of the normal step pulse.Does anyone know why this could be happening  .
Thanks
Les

Pages: 1