Hello Guest it is March 01, 2024, 12:12:29 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - CARTHO

Pages: 1
1
Hi,
Mach3 - Metric

I would like to get the DRO to display only 2 decimal digits instead of the 4 there is now.
Can I alter the display in some editor?

2
Mach Screens / Mach3 displays wrong valde?
« on: June 21, 2022, 01:36:12 PM »
Hi
In Mach3 version 3.043.062 I perform command G01 X1 F1000 in direct mode
The machine moves to X1.000 but the readout on the screen is suddenly X+0.998

This started today and after I have been calibrating all axis.
Now I try to calibrate back to the same distance that I asked to move but still screen differs from my input when I try to make a direct move!

Even when I Run a program for example Z-0.5 the display shows Z-0.4998

Can anyone figure out this and help me out?

3
General Mach Discussion / Error readout in mach3
« on: June 17, 2022, 12:24:47 PM »
Hi
In Mach3 version 3.043.062 I perform command G01 X1 F1000 in direct mode
The machine moves to X1.000 but the readout on the screen is suddenly X+0.998

This started today and after I have been calibrating all axis.
Now I try to calibrate back to the same distance that I asked to move but still screen differs from my input when I try to make a direct move!

Even when I Run a program for example Z-0.5 the display shows Z-0.4998

Can anyone figure out this and help me out?

Pages: 1