Hello Guest it is March 29, 2024, 10:42:24 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - bogger44

Pages: 1
1
General Mach Discussion / Installing new version of mach 3
« on: June 28, 2007, 12:26:19 AM »
I'm trying to install a newer version of mach 3. I have v2.05 running and everything works.
 When I instal v2.65 it won't work. When I load g code it dose'nt load it all and gives an error:  Radias at beggining of arc differs from radias at end of arc on line 20. It also does this if I try to install v2.30

 I'm using PLASMA and this looks like it's the leadin arc that the error is on. BUT the v2.05 has no prob. same g code loaded from the same place.

  I reinstall v2.05 and everything works again.   Thanks for any help.

2
General Mach Discussion / Loading Mach 3 2 65
« on: April 29, 2007, 12:54:01 PM »
I have a pre packaged table it was working ok I upgraded to the new nach 3 2 65 and it won't regen. toolpath past line 19 it says error plasma. o.o56 inch kerf 1/4
radius to end of arc differs from radius to start on line #19
and even before I have trouble scroling through the code if it screwed up to restart in the middle of a program still would'nt go past line 19.
I'm running a dyna cnc table with cand cnc thc mp 1000 sheetcam and mach.

3
General Mach Discussion / plasma floating z zero offset
« on: May 02, 2006, 05:56:20 PM »
I don't know where exactly to put in the z offset to account for the floating head offset it's .065 I know to goto config.-homing/limits but I don't know which line to put it in. I'm cutting a tear shaped part out of 3/8" steel with a 3/4 hole in the center when it cuts the hole it dives the torch into the metal but it cuts the outer pretty good. I don't have any offset in the program I'm using sheetcam with the proper pierice height them after pierice it dives into the metal for the whole circle then it adjusts quickly to cut the outer. Am I doing something wrong? other than the z offset. Thanks.


Pages: 1