Topics

1

VB and the development of wizards / Lamello clamex wizard

« on: April 05, 2023, 05:22:41 AM »

I have made a wizard for the lamello clamex.
https://youtu.be/WWSYfu6Pj50

2

VB and the development of wizards / infrared screen

« on: April 30, 2020, 10:15:07 AM »

I want to make a makro for a infrared screen.
Only while running a G-code and there is an input from the infrared screen .
The machine will go in reset or stop state.
Where do I have to start?

3

Third party software and hardware support forums. / XHC no aftersale!

« on: February 27, 2020, 04:35:46 AM »

XHC products are a no go  when you want after sale service.

4

VB and the development of wizards / offset tool

« on: February 28, 2016, 03:01:19 PM »

How can give an offset in X and Y direction on a tool like this one?

http://www.veldmanslijptechniek.nl/aggregaten/freesaggregaten/5449-freesaggregaat-1-er25-/-iso30.html

5

VB and the development of wizards / message if the Y distance is to big

« on: February 24, 2016, 01:06:28 PM »

I am busy with  a wizzard.
I have a code what add some values to find a Y position.

Code: [Select]

If GetUserLED(1071) Then
Code"G00 Z"& SafeZ &"X0 Y" & een + ZgD + twee + ZgD + drie + ZgD + vier + ZgD + vijf + ZgD + zes + ZgD + zeven + ZgD + acht I want to make a messagebox what will tell me when the sum off the values exceed the machine boundry in the Y axe.
Is this possible and how?

6

General Mach Discussion / OD fillet 2

« on: March 03, 2012, 11:59:00 AM »

strange behaviour with the OD fillet 2 from the lathe wizards?

7

LazyTurn / strange behaviour

« on: February 26, 2012, 03:33:13 AM »

what is wrong?

8

dspMC/IP Motion Controller / allen bradley bru 200

« on: September 22, 2009, 03:55:29 PM »

I own a big wood router, it is a Sanom build in 1994.
the drives and motors are Allen Bradley, drives:  AC230 volt BRU 200 analog and brushless DC 230 volt servomotors f series Allen Bradley 3.3hp max 20 Amp
Is there someone  who can tell me if the dspMC/ip is the right choice for me?
I have the manual for the drives and motor, they run only one direction with simple wirering,
regards,
Cees

9

*****VIDEOS***** / South Bend 9A build 1936 and lazyturn

« on: April 12, 2009, 03:20:26 PM »

http://www.youtube.com/watch?v=cfWBzBsOsxs

10

Show"N"Tell ( What you have made with your CNC machine.) / digitizer

« on: January 25, 2008, 07:02:51 PM »

a 2D digitizer, for me it's a great step forward to make teakdecks on my router
http://www.olgerstimmerwerk.nl/digitizer/Digitizer.htm