Hello Guest it is March 29, 2024, 11:39:29 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - abomb55076

Pages: 1
1
General Mach Discussion / Attaching a e-stop button to maxnc??
« on: June 29, 2006, 12:32:45 PM »
Hello, i have a maxnc unit and i was woundering if anyone knew how i can attach a emergency stop button on to it (without cutting any of its wires or opening it up). I already have a button but i dont know where to hook it up.

2
General Mach Discussion / Conversion software??
« on: May 05, 2006, 11:34:30 PM »
HEy, I was woundering if anyone had any good ideas of a good program thats free that i could download so i can convert files from solidworks into something usful in mach. I cant use dxf because i want to make the things have depth and stuff and i dont know how to make depth and the 3d sort of thing unless i use solidworks.

3
General Mach Discussion / BEst controller or driver to use w/mach3
« on: May 02, 2006, 08:47:05 PM »
what is the best controller setup to use excluding the gecko drives because they cost too much. I was thinking about that hobby cnc kit but do those work with mach3 and are those any good?

4
General Mach Discussion / MaxNC not working!! No movement.
« on: April 24, 2006, 11:07:22 PM »
I have a maxnc 10 or 15 I think and I wanted to use mach 2 or 3. When I try to use the maxnc mode or watever it doesnt seem to work and i dont know how to set up the pins or anything either. I have no idea wats wrong. I think my port is right. i have it set at 0x378 or something close to that and thats what it said on the video tutorial. Please help!! ???


IM confused!!

Pages: 1