Topics

1

Mach SDK plugin questions and answers. / How to start with SDK

« on: December 28, 2010, 10:12:41 AM »

Hello, I want to make a small plugin for Mach3, I've experience developing in c++, (Is my job),

Where may I download the Sdk and some samples?? Or find a "Starter page",

Thanks for all,

Regards
Rey

2

Show"N"Tell ( What you have made with your CNC machine.) / Helical Gear cutting with Mach3

« on: March 31, 2008, 06:45:06 AM »

A sample of helical gear cut on PVC with Mach3:



Regards,

3

General Mach Discussion / Using Mach3 as Lathe Dro

« on: March 28, 2008, 08:23:19 AM »

Hello Friends, I'm planing to use the mach3 as Lathe DRO, I've seen the screen, but I didn't see how to do some basic things:

In the dro screen, it is posible to change the coordinates manualy?
It is posible to set the focus field with the keyboard? (just to use a numeric keypad near de lathe, and use it to set x,y position without a mouse)

Regards,
Rey

4

Show"N"Tell ( What you have made with your CNC machine.) / Telescope Mount cutted with mach3

« on: February 27, 2007, 09:58:26 AM »

A lot of parts are machined with mach3









more on:

http://personales.ya.com/javier_laina/

http://www.saand.es/joseyana/proyectos.htm

5

Third party software and hardware support forums. / Mach3 and gecko G340

« on: February 27, 2007, 09:44:57 AM »

Hello, i'm configuring mach3 with gecko's 340 drives, it has an usefull alert signal, on an input/output pin, that helps to emergency stop on error, but when this condition ocur the drive needs this pin to put high for 5 secons, can be this configuration done on mach3 to "reset" the geckos from the program.


Regards
Rey