Hello Guest it is March 29, 2024, 08:12:31 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - 50sCarStuff

Pages: 1
1
General Mach Discussion / Mach3 THC301d pin numbers
« on: October 14, 2021, 06:43:59 PM »
I running Mach3 with a Texas Microcircuit THC301d with a parallel cable to com port 2. Everything was working fine till my break out broad for the servos went dead. Got a new break out broad installed and got it up and running but my THC doesn't work. I think I changed a few pin numbers. I should have recorded everything. Does any one have an installation manual or the the pin numbers for the inputs and outputs used by the THC301d.
Inputs port 2
E-Stop
THC on
THC up
THC down
Outputs port 2
I do not know what's needed for outputs.

2
Mach4 General Discussion / THC301d pin numbers
« on: October 13, 2021, 06:56:48 PM »
I running Mach3 with a Texas Microcircuit THC301d with a parallel cable to com port 2. Everything was working fine till my break out broad for the servos went dead. Got a new break out broad installed and got it up and running but my THC doesn't work. I think I changed a few pin numbers. I should have recorded everything. Does any one have an installation manual or the the pin numbers for the inputs and outputs used by the THC301d.

Pages: 1