Hello Guest it is March 28, 2024, 12:59:57 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - gait12

Pages: 1
1
Hi,

I would like to mill the same piece many times (array in XY plan) using different offsets of work coordinate systems (WCS) G54, G55, G56, etc.

My problem is due to the tool lenghts compensation after a tool change : the Z offset is modified ONLY in one WCS (the last used).
Of course I need the Z value to be corrected in EACH WCS I work in.

The Work_Offset_Table shows clearly that only the Z value of the last WCS has been corrected, the others are unchanged.

How could I get this ?

Many thanks, hope you can help me to fix this concern.

Guillaume

CAM Fusion_360 / NC Mach3

Pages: 1