1
Mach4 General Discussion / Modification help
« on: March 24, 2023, 10:45:36 AM »
I'm using Mach4 with a EES/Warprunner and the Warprunner screenset. Below is somethings I'd like to modify. I've a newbie when it comes to editing Mach4.
1. Is it possible to make the machine jog at a slow rate until it's been homed? Issue is sometimes the guys forget to home the machine and it gets rapid jogged into the hard stops.
2. I would like the keyboard input enabled automatically. Currently, you have to click on the jogging tab and enable them at startup.
3. Under the jogging tab, there is a slider to change the jogging feed rate. It would be really convenient when positioning the torch if you could easily click a button for pre-set jog percentages. I'd like to put the buttons on the file ops tab as that's the tab we are normally on.
Thanks in advance.
1. Is it possible to make the machine jog at a slow rate until it's been homed? Issue is sometimes the guys forget to home the machine and it gets rapid jogged into the hard stops.
2. I would like the keyboard input enabled automatically. Currently, you have to click on the jogging tab and enable them at startup.
3. Under the jogging tab, there is a slider to change the jogging feed rate. It would be really convenient when positioning the torch if you could easily click a button for pre-set jog percentages. I'd like to put the buttons on the file ops tab as that's the tab we are normally on.
Thanks in advance.