Hello Guest it is March 29, 2024, 11:57:52 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - kephra

Pages: 1
1
Is there a way?

2
Mach4 General Discussion / Lathe turn cycle only works once.
« on: May 03, 2023, 04:11:31 PM »
After installing build 5036,  the lathe turn cycle only works one time.
After starting Mach4, then entering the parameters for the turn cycle, pressing 'view tool path' loads the gcode into mach4.  But the next time a turn cycle is set up, 'view tool path' does not load the gcode.  This used to work.
To run another turn cycle, I have to exit Mach4 and then restart it.

Is there a fix for this.  Does it work ok for other people?

Pages: 1