Guest
Show Posts
1
Mach4 General Discussion / Mach4 and Autoleveller issues ( CSMIO IP-M)
« on: August 12, 2021, 07:09:00 AM »
Dear experts,
I lost almost all week reading different posts from pervious threads but I couldn't find solution for my problem. I have CNC router, CSMIO IP-M controller, Leadshine closed loop stepper etc, machine works without any problem. Most of the time it is used for stone engraving using V bits and due to unleveled stone surface some letters are too deep and others are not engraved at all. I saw autoleveller as great tool, I use that tool previously with mach3 and LPT cards without issues. But this setup (Mach4 and CSMIO) drives me crazy. I found custom M40 and M41 macros (tnx to joeaverage) and put registry values (ALdata, etc) . Routine look ok, in beginning it makes two measuring moves, ask to create triplet file, continue to make measures and finish procedure. Then problems starts to emerge. First is Mach4 notifications ( Data mismatch value X, value Y) and number of windows is equal to number of measuring points. After that file is created but Z value is "shifted". For example, in point B values of X and Y is from point B, but Z axis is from point A. That makes totally wrong surface plane.
Do you have and advice? Thank you in advance.
Samir
I lost almost all week reading different posts from pervious threads but I couldn't find solution for my problem. I have CNC router, CSMIO IP-M controller, Leadshine closed loop stepper etc, machine works without any problem. Most of the time it is used for stone engraving using V bits and due to unleveled stone surface some letters are too deep and others are not engraved at all. I saw autoleveller as great tool, I use that tool previously with mach3 and LPT cards without issues. But this setup (Mach4 and CSMIO) drives me crazy. I found custom M40 and M41 macros (tnx to joeaverage) and put registry values (ALdata, etc) . Routine look ok, in beginning it makes two measuring moves, ask to create triplet file, continue to make measures and finish procedure. Then problems starts to emerge. First is Mach4 notifications ( Data mismatch value X, value Y) and number of windows is equal to number of measuring points. After that file is created but Z value is "shifted". For example, in point B values of X and Y is from point B, but Z axis is from point A. That makes totally wrong surface plane.
Do you have and advice? Thank you in advance.
Samir