Topics

1

General Mach Discussion / slow jogging speed

« on: January 03, 2023, 01:14:37 PM »

Hi all
I have a strange problem in mach3,my jogging speed is set a 75 and with the arrows its jogs just fine.
But when i add a code in the bar for example x0 z1 and enter its jogs horrebly slow with a lot off noise.

2

General Mach Discussion / mach3 xhc WHB04B mini lathe

« on: July 30, 2022, 03:51:47 AM »

hi i have the XHC WHB04B pendant and i like it very much,but there is one thing that i cant find out.
The z axe dro output are the same on pc and pendant,but my x axe shows different numbers,e.g- x axe on pc 100 mm  and the pendant shows 50 mm or is that normal.

3

General Mach Discussion / fusion 360 to mach3 mini lathe.

« on: July 18, 2022, 01:57:54 PM »

as i am still learning i use the turn wizzard.

I fill the data in the turn wizzard and post it to mach3,then i go in the manual screen and set the beginning point for my workpiece with part zero. zero z.
Its worked perfectly no problems
But when i post a drawing with fusion360 to mach3 and setting my zero z in manual mode the program begins not even close to my workkpeace,infact my x axe goes al the way backwords + is that

4

Mach4 General Discussion / part zero

« on: July 14, 2022, 04:22:06 AM »

In mach 3 you had a button part zero to set your workpiece 0 point,how do i set the workpiece 0 point in mach 4.

5

Mach4 General Discussion / reverse axe direction

« on: July 12, 2022, 03:42:40 AM »

Hi
how can i reverse the axe direction for my mini lathe.
The -z and the +z runs the same direction and also the -x and the +x runs the same direction.