1
General Mach Discussion / Techno-ISEL Mac200 setup question
« on: July 10, 2008, 05:54:40 PM »
I have just graduated from a very small home built CNC router to a Techno-ISEL Mac200 controller/ Router system.
My problems come with the pin setups for the controller and other settings to make Mach 2 or Mach3 work with it. By any chance is there someone on here that has one of these beasts that can help me get it up and running?
The documentation that I have from Techno-ISEL does not contain the right information I am looking for as far as the pin configuration betweent he computer and the controller. I'm sure this is a setup issue with Mach, but I have no clue where to get started.
Thanks,
Ken
My problems come with the pin setups for the controller and other settings to make Mach 2 or Mach3 work with it. By any chance is there someone on here that has one of these beasts that can help me get it up and running?
The documentation that I have from Techno-ISEL does not contain the right information I am looking for as far as the pin configuration betweent he computer and the controller. I'm sure this is a setup issue with Mach, but I have no clue where to get started.
Thanks,
Ken