Topics

1

General Mach Discussion / atc spindle test crashes into the tool holder rack

« on: August 16, 2021, 05:34:02 PM »

avid cnc with cncdepot atc & mach4
setup the m6 file with all the parameters
when I do a air cut it goes over to the rack and hits it. instead of raising up to clear it first
in the m6 file Z is the actual spot where the spindle goes to park the holder
is this wrong

2

Mach4 General Discussion / Z axis always goes to the top

« on: May 16, 2021, 09:57:39 AM »

First time run. I load the g-code from Aspire using the Avid Txt save file. When I try to run it sends the spindle to the top and resets
Please..what am i doing wrong. Have watched videos but to no avail
thank you
file included