1
General Mach Discussion / Mach 3 and servo motors =S
« on: April 12, 2021, 09:33:36 AM »
Hello all
I am new with this topic. I am going to build a small CNC using servomotors (X-Y axis with 0.75kW motors ans Z a 1.3kW motor). When I was at University I used mach3 for a project but with steppers, I want to know if I can use mach 3 for the servomotors, also if you know some controller board to use with servo because in my search only appearce boards for steppers.
Hope you can help me.
Regards
I am new with this topic. I am going to build a small CNC using servomotors (X-Y axis with 0.75kW motors ans Z a 1.3kW motor). When I was at University I used mach3 for a project but with steppers, I want to know if I can use mach 3 for the servomotors, also if you know some controller board to use with servo because in my search only appearce boards for steppers.
Hope you can help me.
Regards