Hello Guest it is March 28, 2024, 10:22:21 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Strangar

Pages: 1
1
General Mach Discussion / Mach 3 Soft Limits Issue
« on: April 10, 2021, 03:02:34 PM »
I am having issues with my Soft Limits.
My machine is capable of
     X - 101.5"
     Y - 54"
     Z - 12.5"
I have set my limits in Motor Home/Soft Limits to these values
     X - Max:101.5 - Min:0
     Y - Max: 54 - Min:0
     Z - Max: 0 - Min: -12.5

Y and Z soft limits work perfectly.

The issues is that I can turn on my Soft Limits when my X is lower than 73.63" and it works all the way up to 101.5 when shuttling. The issue is when my CNC has a X value greater than 73.63" and I turn off Soft Limits I cannot turn it back on until I am under 73.63". Also if I have a job that is larger than 73.63" I cannot run it with soft limits enabled. I have been running without soft limits for a wile and would like to get this issue resolved.

Pages: 1