Guest
Show Posts
1
General Mach Discussion / HELP please Mach3 won't run my board
« on: September 21, 2007, 01:08:30 AM »
I'm totally new to the cnc world but i managed to make the table and a board to control the motors and i'm using this board http://pminmo.com/3axis/3axis.htm and i tested it with another software and it spin the motors very well but when using Mach3 i can't move the motors at all i used the configuration as instructed in the board manual for pins on the LPT port and also this configuration http://www.pminmo.com/wiki/index.php?title=MACH3_setup
which is made specifically for this board with mach3 but nothing happens at all but i noticed that when i run gcode file " the road runner" and start cycle i notice very very small movements on one motor like 2 or 3 tiny tiny steps but thats all
please help me configure my board with Mach3
BTW i'm running a new computer with 3.2GHz processor if thats matter
thank you in advance
which is made specifically for this board with mach3 but nothing happens at all but i noticed that when i run gcode file " the road runner" and start cycle i notice very very small movements on one motor like 2 or 3 tiny tiny steps but thats all
please help me configure my board with Mach3
BTW i'm running a new computer with 3.2GHz processor if thats matter
thank you in advance