Hello Guest it is March 29, 2024, 06:01:34 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - SSIRON

Pages: 1
1
G-Code, CAD, and CAM discussions / artcam pro 2008 jerky motion issue
« on: June 03, 2010, 11:36:14 PM »
artcam pro 2008 jerky motion issue

I am having some trouble getting smooth motion out of my router.  I am under the impression, i can not recall why, that cv does not work with arc moves.  I actually have two systems.  A plasma system where I had to change the posts in sheet cam from mach with arcs to mach with out arcs.  Seemed to be necessary to get smooth motion out of plasma table.  The router on the other hand is still aproblem.  The posts in Artcam does not offfer a post with out arcs.  I should metion I have limited exposure to gcodes.  I just know the problem is associated with the I and j codes.  ANyone had any insite to this work be greatly appreciated

Ron
www.saltspringcnc.com

Pages: 1