Topics

1

PoKeys / Not able to get PoKeys56U to work with Gecko G320X

« on: November 20, 2013, 01:17:53 AM »

I have been trying to use pokeys56U to output step/dir to my gecko drives to control servo, following the instruction I still dont get anywhere, has anyone had luck doing this, and if so, any pointers?

Using Pokeys software 3.0.65 with Pulse engine enabled.

Thanks,
Russ

2

PoKeys / Two buttons doing same thing, possible?

« on: September 27, 2012, 10:27:50 PM »

I have kbd48cnc keyboard, and on my control panel I also have external cycle start and feed hold buttons.

When I assign the oem code 1000 to cycle start button on pin 38 the cycle start button stops working on kbd48cnc, and same with feed hold. Is there a way to have both working?

Appreciate the help,

3

PoKeys / Installing pokeys software issue

« on: September 21, 2012, 04:29:18 PM »

I'm trying to install pokeys software on my mill computer(which is no where near internet, and is very permanent at that location)

Pokeys keeps asking for .net framework, i have downloaded 4.0 and 3.5, installed, but it still doesn't like it. Is there version of pokeys software that already comes packaged with .net framework it needs? For cases like mine that would be very convenient. By the way, I'm on Windows XP

Thanks...

4

Mach Screens / Minimal mouse, softkey/button oriented screen

« on: December 15, 2011, 08:21:16 PM »

I'm looking for softkey oriented screen and wondering if anyone has already made one?

Has anyone made one?

Thanks in advance,
Russ

5

Mach Screens / Minimal mouse, softkey/button oriented screen

« on: December 15, 2011, 08:12:05 PM »

I'm looking for softkey oriented screen and wondering if anyone has already made one?

Has anyone made one?

Thanks in advance,
Russ

6

LazyCam (Beta) / lazycam wont do pockets or offsets

« on: July 09, 2009, 11:37:35 AM »

Hi guys, i have a PRO version of lazycam(license bought 2 or so years ago) and last week i was using it and it was working great then my hard drive died, ordered new one, reinstalled Win XP, reinstalled mach3 and lazycam, put license into mach3 folder.

When I open lazycam> help> about> it shows that its PRO version and my name, i import pretty much same dxf i was working on last week with just few hole positions shifted, go to use offset and all it seems to do is make offset for 0 dia tool, and tool is set up properly with diam, feed rate, plunge speed, spindle speed etc all set to what i want it to be.

Any one have any input? i reinstalled lazycam thinking it might help but didnt do anything, even installed it on spare older laptop which has clean install of xp with nothing else installed on it and still doing same

Any input is welcome, Thanks..

7

PoKeys / Mouse emulation

« on: June 15, 2009, 05:24:33 PM »

is there a way to emulate a mouse atm? what i really need is left click, and if possible x, y positions, anyone can point me in right direction?


Thanks in advance